Probleme paramétrage primus fs7

[paris-laverie]

FAILURE 13: HEATING FAILURE
If the heating resistors are not functioning : failure message 13 will be displayed.
The failure message is generated when the temperature is not raising with 3°C in 10 minutes time.
For HE = on : wait for heat selected => fault message 13 can occur
For HE = oFF : no wait for heat selected => fault message 13 will not occur
DIAGNOSE:
1. Check if the heating contactor is activated If the heating contactor is not activated: repair the
wiring or replace the contactor
2. Check if the heating resistors are heating If the heating resistors are not heating:
Repair the wiring or replace the defective resistors
3. Check if the temperature sensor is
functioning
If the temperature sensor is defective: replace the
temperature sensor
4. Check the output relay that powers
the heating contactor
If the relay is broken, replace the electronic board
5. Check the output relay that powers
the heating contactor
If the relay is not broken, but doesn't receive a signal
from the electronic board, replace the electronic board